250w Car Engine Oil Pan Sump Tank Heater Mat Silicone Heating Pad

• Condition: 100% new
• Color: Orange
• Material: Silicone
• Mat Size: approx.13x9x0.15cm(5.12x3.54x0.06")(LxWxT)
• Wire Length: approx.210cm(82.68")
• Voltage: 110V
• Power: 250W
• Suitable for: 4-14 quart oil pans
• Item included: 1 x Heating Pad (Without Plug)
• Note:

  1) All dimensions are measured by hand, there may be small deviations.

  2) Color may vary slightly due to the color setting of each individual monitor.

  3) Do not cut pad.

  4) Do not use on batteries.

  5) This heater can only be used on a metal pan or tank with a smooth float surface. It should never be installed on a plastic or poly container.

Product Dimension:

Feature:

1) Oil and acid resistant, waterproof.

2) Easy to install with adhesive backing.

3) Safety and energy saving.

4) Fast heat rises.

5) Keeps engine oil warm. Prevent cold start damage, reduce engine wear.

Installation:

1) Clean and sand reservoir to bare metal. remove all dirt, grease, oil and other contaminants using a degreasing solvent. (Do not use gasoline or acetone).

2) If heater is to be installed on a vehicle, try to run the engine to pre-warm the oil pan.

3) Peel off backing and apply pad to reservoir making sure that there are no air pockets or creases in the pad. use a roller or spreader to remove them.

4) Seal the edges of the heater with high temperature silicone to insure proper protection to the edge of the heater.

5) Secure the cord up and out of the way of any obstructions, making sure that it does not hang down from the pan or touch any hot or moving.